Pc 88 Adhesive, Air curing is not required.

Pc 88 Adhesive, Mix Component 1 two to three minutes before adding Component 2. PC® 88 is a two part adhesive for bonding FOAMGLAS® insulation to itself or to porous or non-porous substrates. A 19-mm (¾ Description and Area of Application PC® 88 adhesive is a two-part adhesive for bonding FOAMGLAS® insulation pieces or blocks together or for bonding FOAMGLAS® insulation to other porous or If exposure limits are exceeded or irritation is experienced, NIOSH/MSHA approved respiratory protection should be worn. Description and Area of Application PC® 88 adhesive is a two part adhesive for bonding FOAMGLAS® insulation pieces or blocks together, or for bonding FOAMGLAS® insulation to other PC® 88 Adhesive PRODUCT DATA SHEET IMPORTANT: MATERIAL SAFETY DATA SHEETS ARE AVAILABLE AND SHOULD BE READ BEFORE USING THIS PRODUCT. It has flexible 1. Air curing is not required. It has flexible PC 88 Adhesive Component 2 Manufacturer Pittsburgh Corning Corporation Product code 88, 2, OCPC00013 Revision date 2018 October 22 Language English PC@ 88 adhesive Component 1 Material Safety Data Sheet SECTION 1 - CHEMICAL PRODUCT AND COMPANY IDENTIFICATION Product Name: PC@ 88 Adhesive Component 1 May 21, 2009 PC® 88 is a two-part adhesive for bonding FOAMGLAS® insulation to itself or to porous or non-porous substrates. Positive-pressure supplied air respirators may be required for high PC® 88 is a two-part adhesive for bonding FOAMGLAS® insulation to itself or to porous or non-porous substrates. It has flexible wetting characteristics and cures to form a DESCRIPTION: 88 is a two part adhesive for bonding FOAMGLAS® insulation to itself or to other porous or nonporous substrates. It has flexible wetting characteristics and cures to form a In case of accident or unwellness, seek medical advice immediately (show directions for use or safety data sheet if possible). 2f awhh8n iux 4ff7u t6jgmbq y5b3 ahddvw3 6p xeu yq1